Capped End Anchor Points

Product enquiry
Threaded transport anchors are designed for the transport of precast concrete units, like slabs, beams and walls. Whether very thin units or platforms – depending on the type of unit, different anchors can be chosen. Axial, diagonal and lateral tension is easily attainable with PHILIPP transport anchors.

The Advantages

  • Ideally suited to your requirements because the anchors are subdivided into the 12 load levels
  • Maximum load capacity: 20t
  • Can be installed in front or on plane side
  • The anchor is also suited to very thin walls, e.g. garage walls due to its specially slender design
  • Optimally matched mounting aids simplify the installation
  • No parts protruding over the component surfaces
  • High quality of exposed concrete because the small notches on the component surface can be covered by accurately fitting caps in stainless steel

The PHILIPP Capped End Anchor is part of the PHILIPP Transport Anchor System and complies with the „Safety Rules for
Transport Anchors and Systems for Precast Concrete Units“ (Germanregulation, BGR 106).


The anchor may only be used in combination with the
recommended lifting devices.


PHILIPP Capped End Anchors are used for transport of precast concrete units. Multiple uses within the transport chain (from production to installation of the unit) are no repeated uses. Repeated use is only allowed if it complies with the German Approval (DIBt, Berlin No. Z-30.3-6 stainless steel).

Features/Spec

Load Bearing Specification Sheet

Back to top
categories:

Related Products