Load Ring bolted - VWBG-V

Product enquiry

360° swivelling/180° pivoting

Complies with the machinery directives 2006/42/EG

Suitable for all loads which swivel and tilt. Can be loaded in all directions with a 4 : 1 design factor.

Swiveling under full load is permissible provided the inclination angle is not perpendicular to the screw - in direction.

Not suitable for permanent swiveling under full load. Can also be supplied with variable (vario) thread lengths. Easy assembly due to the single threaded tapping. High tensile, inspected suspension ring according to EN 1677-4. The surface is both pink powder coated and zinc plated. Patent 4336779-VARIO.

Choose the attachment points in such a way that the introduced forces are accomodated by the work piece without being deformed. Make sure the bolting surface is plain. Ensure an appropriate bore depth to facilitate an optimal sitting of the engaging surface. Work piece material, at least 1.0037 (St 37).

For light metals, nonferrous heavy metals and grey cast iron, the thread type allocation must be done in such a way that, the WLL of the thread type fulfils the requirements of the respective work piece.

RUD Load Ring

Owing to the presence of the ball bearing, in case of a single transportation procedure, fastening with a flat wrench according to DIN 895 or DIN 894 without using an extension is enough. Without a washer, the seat - engaging surface of the VWBG-V (D) must completely and evenly lie onto the surface of the work piece. Is the VWBG-V to be permanently loaded, it must be tightened with a torque of 10 Nm.

When impact loaded or operated in environments with skewing and vibrations, unintentional loosening can happen, especially if through bolts with nuts are used.

Swivelling lifting point:

  • Loadable in any direction. Safety factor 4 : 1
  • Turnable under load in vertical direction.
  • Not suitable for permanent swivelling under full load, especially in 90° direction.
  • Simple installation, just a thread hole is required.
  • Variable lengths (Vario) available.
  • Can also be used for through holes.
  • Bolts 100 % magnetic crack detected! Surface protection CORRUD-DT
    (20 times better than zinc plating).
  • High tensile, approved suspension ring acc. EN 1677-4.
  • Surface: Ring pink powder coating, housing zinc plated.
  • Type Vario with washer and 100 % crack detected nut.
  • VWBG-V and VWBG are also available with Imperial thread.
  • Turning without jerk due to additional bush bearing washer.
  • Wear marks in the main load directions 45°, 60° and 90°.

Product Code: VWBG-V