PowerPoint® PP-VIP Direct VIP chain connection

Product enquiry
RUD Lifting Points

The first generation of lifting points with a double ball bearing for the direct connection of the VIP chain.

Version PP-VIP.

Connection only with RUD approved components e.g; VCÖH-4, oval link, PP 0,63 t or the 4 mm VIP chain.

Hint : The VIP chain connection is fool proof. When assembling the components, pay attention to the correct WLL allocation. Even under full load, can be turned in a 90° position from the bolt centre line.

Not suitable for permanent swiveling under full load. Choose the attachment points in such a way that the introduced forces are accomodated by the work piece without being deformed. Work piece material, at least 1.0037 (St 37).

For light metals, nonferrous heavy metals and grey cast iron, the thread type allocation must be done in such a way that, the WLL of the thread type fulfils the requirements of the respective work piece. Make sure the bolting surface is plain. Ensure an appropriate bore depth to facilitate an optimal sitting of the engaging surface.

Maximum WLL with the smallest thread diameter. Thread length : 18 mm For a single transportation procedure, bolting in and fastening tightly with a flat wrench is enough.

Without a washer, the seat - engaging surface of the Power point (D) must completely lie onto the surface of the work piece. Is the Power point to be permanently loaded, it must be tightened with a torque of 10 Nm. When impact loaded or operated in environments with skewing and vibrations, unintentional loosening can happen, especially if through bolts with nuts are used.

Securing possibilities: Use of a liquid thread securing medium eg. Loctite ( follow the manufacturer´s recomendations) or positive bolt securing for example using a castellated nut with a split pin, counter nut etc

Product Code: PP-VIP

Features/Specs: